Lumber Tips For Your DIY Shed Project
When buying materials for your shed project, you want to get the best quality that you can find. This doesn’t mean paying the highest price though. You’re not building a piano, but you don’t want added headaches either.
Studs for shed floor, wall and roof framing- Make sure that the wood is not wet when you buy it. Pick up and look down the length of the boards. Select the boards that are fairly straight, and if need be, only have a slight warp to them. Avoid all twisted lumber. They are really difficult to work with. You’ll have knots in the wood. I try to make sure that there are at least no knots at the ends of the board.
When nailing 2 X 4s in place, put the crown up on floors and roofs, and to the out sided for walls. The crown is found when you stand the board on its side and looking down the length. You will notice a slight bend in the length of it. The crown is the upper bend in the middle.
Plywood should not be splitting on the ends or warped. Double check the thicknesses as you buy them and as you install them. 5/8 inch on the roof decking and 3/4 inch on the floor for a typical shed.
